Re: tell tale blockage 3.3 mercury 2002
well i took her out and i'm so happy now :) it runs good, it gets hot but the tell tale flows enough I to keep it from ****ting itself. i'm sure you've all had your problems on the water, but i think i've had a year of nightmares that would top most. it...
Hi everyone,
I have no water coming out of the tell tale on my 3.3 mercury 2002. the guy I bought it off said it never poored out just dripped out, but i'm not even getting that. I took the lower unit off and replaced the impeller. (i hope i did it properly) I know i didnt connect the lower...
Hi everyone,
I just took the lower unit off my 3.3 mercury to replace the impeller which doesn't seem to have fixed the problem of no water coming out of the tell tale. I had it in neutral when i took it off. I had some issues with putting it back on but once i succeeded, it is now stuck in...
Hi everyone,
I want to know if I need and outboard stand for my 3.3 hp mercury or can I stand it on the leg against the wall. I have been doing this with my 2.3hp chinese motor coz its only 10kg. the mercury is about 12 kg so not much difference, but wondering if it could damage the lower unit...
Hello again,
As I mentioned on another post I have going. I have found that lower unit gear case was not bolted shut and it came open. And so I used it 3 times without knowing. ( I know this because the outboard was not new as I accepted it as an exchange for another outboard that needed...
Hi guys,
Firstly i have to apologise as i know I have a 2.3hp new concept outboard that is giving me issues. It's an air cooled motor but I think it's kinda water cooled as well as it has the water inlet holes on the lower unit and it has an idle relief port on the upper leg, but it doesn't...
