Does anyone know where to find a wirind diagram for my 1979 Evinrude 85hp? The previous owner cut the wiring to remove it from his old boat and I want to make sure everything gets reconnected correctly.
EDIT: It is against our rules to solicit private transactions in the forum. It is against...
I posted in another thread that I too was getting a high pitched whine yesterday when I went to start my motor but I thought it had to do w/ a dead battery since it was pretty low. Well I charged it overnight and tried again today at lunch and I get nothing but the whine when I turn the key. It...
Ok after bringing my 1973 Mercury 650 back from the dead I seem to have several fuel leaks. I got the motor running but only buy spraying fuel into the carbs so I'm sure I'll need to pull the carbs and clean them if not rebuild them. The leaks I'm getting appear when I use the primer bulb and...
I have no idea what year or make of this boat but if I didn't already have a project boat in my garage I'd be running out to look at this one....http://omaha.craigslist.org/boa/783786969.html
I scored some major deals on Ebay the last 2 days. I've got a 73 Mercury 650 w/ no spark and a starter that froze up on me while troubleshooting. Well I found and won a good used starter for $9.99, a new after market switchbox and coil replacement for $99.00 and a good used stator for $15.50...
I ran across a thread a while ago that had links to someones pics of their homemade back to back seats made from 4 folding boat seats. I'm planning on doing the same thing w/ seats from an old abandoned boat project but now I can't find the pics to save my life. Anyone know of the pics I'm...
I'm going tomorrow to look at a new motor for my boat. It's a 1980 Mercury 70hp that the guy says was fouling the #1 cylinder. He says the marine shop told him it needed carb work and timing adjustment. What causes plugs to foul.
He's asking $400 for it.
I'm restoring a 1973 Thundercraft tri-hull that I bought w/o seats. There's the outline of where the old back to back lounge seats went but exactly how does one go about mounting new ones. Are they bolted in place or just glassed in place?
I have an the opportunity to purchase a 1969 lark 2 40hp in good running condition w/ all the controls for $300. Does anyone know if that model is a long shaft or a short shaft? I'm thinking of replacing a Mercury 650 with it but I need to know if it's long enough to work on my 1973 Tundercraft...
I'm in the process of trying to bring a 1973 Mercury 650 back to life and have run into a new problem. While trying to figure out why I have no spark yesterday the starter suddenly seemed super sluggish during one turn of the ignition then after that all I get is a loud click from the starter...
I just got a 1973 Thundercraft tri-hull w/ a 65HP Mercury on the back with no spark. By just looking at the outside condition of the distributor cap I'm pretty sure that's the problem but since the cheapest one I can find is $125 for a used one and $225 new since they're discontinued I want to...
I'm looking for a wiring diagram for my older than dirt 60HP 4cyl SeaKing outboard motor. Unfortunately it doesn't have the original controls so I'm having a heck of a time figuring out the wiring to get it running. I know it ran before I got it and it's got great compression and even the...
