I have a 1977 OMC I/O and the current prop i have on there is a 14x14. It's really chewed up and I would like to get a new one.. the problem is I can't seem to find one.. Does the pitch have to be 14? i'm not really sure how that would effect the performance of the watercraft. Thanks
well guys I took my boat to the lake, everything on the boat works fine, the engine cranked right up with no problems. As I put it in gear the boat went foward no problems, but when I applied throttle to the engine the boat went faster, but It seemed to be struggling to achieve speed... Any advice?
hey guys, I have a 1980 Montgomary ward (Chrysler) 9.6 outboard and the compression spring on the rip cord snapped on me. Is there anyplace online where I can get a new one? thanks
hey guys I just took out the old trim motor on my 1977 fiberform, and I got a new one to replace it. It wasn't working when I flipped the switch all I heard was a clicking noise. The first thing I did was to have the selinoide tested and it came back OK. I tore out the old motor and it was...
I have a 1977 fiberform boat and I was inspecting the hull and noticed some holes and some broken pieces on my boat. I took some pictures and would like to know what I can do to repair these. I want to get it back in the water ASAP.. Thanks
Hello, I just bought this 1977 Fiberform boat I was inspecting the hull (should have done that before I bought it) and found some issues that I think need taken care of before it hits the water.. Here are some pictures I know the outside looks bad but it's just paint peeling off. Is there a way...
I want to flush my engine to see if the water pump and impeller are working correctley before I take it out on the lake. My question is where do i hook up the water hose on the outdrive. From what I can see there is a water pickup right under the prop, and then there is another hole on the front...
