Ran a 1987 Johnson 40 hp hooked up to a flush device and seems to be litttle water flow.... There is some but not what I have seen out of my other motor(92 Johnson 60hp)... Think it would be ok or shall I just replace the whole water pump?? I suspect the impellar would be the problem. Any...
Hey Guys. Had to switch the motor tonight./ Went from a 1992 Johnson 60 horse to a 1987 Johnson 40 horse. There more wires from the 92' then there is for the 87. What wires are the ones I need to make sure to connect.....and one other thing. Can I take the trim tilt system off the 92 and add it...
Hello Guys me again...... Question for you all. Can I replace a shot 1992 Johnson outboard with a 1973 Evinrude outboard without any major problems??? Both are the same HP at 60
Ok Got a new Lower Unit for my Johnson 60 horse and tried putting it together. and well can not get the shift Rod connected. There is a hole at the end of the rod. Is there supposed to be a pin in there. I do not remember when I pulled the old one. Was searching the boards and net fgor some help...
Hit an underground object and ended up cracking the lower unit. Well hey I am guessing it might have been a rock....Also tore up the propellar and lost reverse in the process. One exsensive rock I say. Replaced the prop and have yet to pull the lower unit to check the shift rod but oil is...
Ok Have a Boat and a Motor. Just a start but hey it works..... uh anyways. Running at full speed with a 60 Horse Johnson on it likes to go right withut any help. Now trying to turn it left is a chore because it pulls hard.. Is the propellar off balance?
Ok Have a Boat and a Motor. Just a start but hey it works..... uh anyways. Running at full speed with a 60 Horse Johnson on it likes to go right withut any help. Now trying to turn it left is a chore because it pulls hard.. Is the propellar off balance?
I have a hole in my boat that I recently purchased and yes was aware of it from the start. The hole is about 2" in diameter. Now do I neeed to fill the hole first or should I just start placing the foberglass over the hole and not worry about the gap. And also is the gel coat needed to protect...
Ok this may sound strange but I am looking for a new boat. Along the lines of a Mirrocraft or Starcraft. Anyways the question is. Do I negotiate the price of the boat or is the price final? I know it might depend on the dealer also but input would be great help.
Ok this may sound strange but I am looking for a new boat. Along the lines of a Mirrocraft or Starcraft. Anyways the question is. Do I negotiate the price of the boat or is the price final? I know it might depend on the dealer also but input would be great help.
How in god's name can a person remove a bearing off a prop shaft? An easy way or a hard way. I amnot caring... How do I just get it off. Please and thank you for all who respond to my plea for help
I am looking inot welding the lowerunit due to a crack and putty is just not working. What is the metal of the unit or what types of metals were used in the 60's for lower units. Was it aluminum..? <br />1969 scott McCulough :confused:
I have a nice sized crack in my lower unit and yes of course I am leaking oil. Do not know how it got theree but I do know I can't seem to fill the crack. Would solder be able wo withstand the kind of torment that goes thru with a lower unit. The engine is an old 1969 McCullough Any suggestions?
I have a 1968 sears engine(made by McCullough) that is not cooling properly (at all) I have replaced the impellars in the water pump and it is still not working. I have put my hand near the intake and I am not feeling any suction. Is it possible the impellars are in wrong or maybe something is...
