Thanks Supreme, but do you mean part #34?
I've installed that, it has a small split and is a bit thinner than this ring.
I thought this ring should go somewhere in there, but don't see where.
I had my engine rebuilt and am assembling a year later, but with three parts left over. Any ideas where they go would be appreciated. The little metal bushing was under the carb area and fell out when I tilted the engine, so it may have been there for decades. The big ring is a brown plastic...
Does anyone happen to know the inside diameter of this hose?
Should I use a Mercruiser part, or will good gas proof hose work OK?
Is it hard to install with the out-drive in place, any tips?
Thanks!
-Chris in NW Ontario
Hi, I have been experiencing missing when motor is cold and on low RPM's. Spark plugs show milky grey liquid (water). No water in fuel, so I pulled a head just now and attached pics. I have a new head gasket to install, I just wanted to confirm with more experienced folks that this is the...
Hi, my 1995 15 hp Johnson has a high speed miss on the top cylinder, I think. The boat runs fine at low speeds, but will miss off and on every few seconds at high speeds. Backing off on the throttle will actually make the motor run a bit better, but nothing like what it did years ago.
If I stop...
Hi all, I'm new to the group, though it's saved my bacon more than once, thanks.
My question concerns my Evinrude 1985 or so 4.5 HP kicker on my sailboat. I am thinking about putting a charge coil (part #0581635 I think) to top up the batteries while away from shore power.
Does anyone have...
