Recent content by nydoug

  1. N

    2000 Wellcraft

    HEY GUYS, I'M LOOKING AT BUYING A 26' 2000 WELLCRAFT COASTAL walk around with a 454 engine. Does anyone have any info on this year and type of wellcraft? Were the stringers, transon wood? Any info would be GREATLY appreciated. Thanx Doug
  2. N

    McKee Craft

    Hi Guys, I just bought an 1984 McKee Craft with a built in gas tank. The motor is not running and the previous owner disconnected the gas line to the engine at the engine. I'm a little sceptical about using the gas tank is there any real good way to clean out an old gas tank? Thanx NYDOUG
  3. N

    Jet ski Cooling

    Does anyone know about Jet ski cooling?
  4. N

    Jet Ski Cooling

    I have a 2000 Sea Doo jet Ski, there are two cooling water ports that come out the back. Only one shoots out water, both hoses are clear of any obstructions. I pulled the one that was not working off where it attaches to the engine and no water is coming out. I figure if it's pumping water to...
  5. N

    Painting Boston Whaler

    I have an old 1963 Boston Whaler. I would like to paint it and fix it up a bit. Is there any trick to painting it or can I just buy some paint and slap it on? Thanx for any help.
  6. N

    30 HP Evinrude

    Hi, I have a 30 HP Evinrude I think it's about a 1984. It is a tiller (handle) type with the throttle etc.. on the arm. My question and it might be stupid is there anyway to convert this motor to controls that would mount on a console? And if so is it costly and or complicated?
  7. N

    Fill/Drain Ports 125HP Force

    Hi guys, I have purchased a 1988 125HP Force, I want to change the lower unit oil but for some reason it appears that the Fill/vent port and the drain port are side by side? I have had many outboards and outdrives and all of them had these ports --One on top and one on bottom never side by side...
  8. N

    Wellcraft Boat

    Hi I bought a 1972 17Ft Wellcraft fishing boat. It had quite a bit of bottom paint on it, I took it out and unfortunitly I discovered a LOT of leaks in the bottom of the hull. Of couple of 2 foot cracks that are leaking. Is there any fix for this or am I screwed? Keep in mind I don't want to...
Top