Recent content by ohioriverrider

I replaced the impeller again in addition to the entire pump housing and seals (none of which looked bad. I also replaced the thermostat and while everything was apart I flushed out the back flush with compressed air and water as well as the tell-tail hole. Put it back on the river yesterday...

I have scoured the internet now and haven’t seen the same issue encountered that wasn’t a motor positioning issue so I’ll ask it here. I have a 2018 75HP Mercury four stroke on a 2018 Bayliner e16 (factory engine). I’ve owned the boat for a few years never had an issue getting a tell tail at...

Update: hooked up VesselView today and ran it on the hose for a few minutes (it’s terrible weather in Ohio today). No faults were triggered so to anyone else reading in the future with the same shake/vibration as of today it looks like we’re good 🤷‍♂️.

Yep plan to change oil this weekend and have new low pressure fuel filter on the way as well. Is there a trick to removing the clamp on the fuel rail to remove that filter?

Thanks for the quick response! I’m am super particular about maintenance and am just concerned about burning up a piston if it’s a faulty injector or something. I’ll keep this thread posted if the vessel view shows any codes when it comes in the mail tomorrow. I hope you are right and it’s...

Hello, new to the forum and boating. I have a 2018 2.1 4 stroke EFI that seems to have some shaking/vibration in neutral and at idle. Boat (2018 bayliner e16) drives great, hole-shot is good, holds speed fine. But on the hose or in the water at neutral the vibration is not terrible but it...