FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Good idea - i should have thought of that .
Bet I can find some small fittings in the plumbing dept. @ lowes depot .
Plus I only have a tiny air compressor .
OK on the using air to push out impeller debris .
NOT - taking powerhead off ,, if air doesn't work I'll drop the drive unit .
I'll be changing the impeller every 2 years from here on out - that's for sure .
Thank you folks for all the help ! ! !
-Mike
Not the lower - I meant the drive unit - the whole shabang off the bottom of the engine .
Already pulled and replaced impeller - no water due to clog.
Compressed air at pisser exit port ? OK idea or no ?
I hardly ever used the 2.5 , also have a 6hp , yes impeller fins are gone .
Same impeller it came with 10 years ago - yeah I know - should have been changed long ago .
Was running in 5gal. bucket - it goes deep enough to submerge inlet but just read that water level should go above where...
Hello Guys ,
Great forum -glad i found it.
I have an 98' 8hp 2cycle that doesn't seem to want to pump fuel to the carb very well ,i changed the diaphram gaskets and it worked better for a short while -but now not pumping very well.
Also it seems to flood and wet the plugs easily ,i friend and...
