Recent content by Old and Rusty

  1. O

    I need help!!!!! Look at topic below-Want replace water pump L.unit won't separa

    Check out Want to install new water pump but lower unit will not separate<br />Posted June 26, 11:13 a.m.<br />Look at my last posted message and please give some advice.<br />Thanks
  2. O

    Just purchased 1974 boat made by Invader..where can I get info on this boat comp

    Just bought a 1974 Intruder 16' fiberglass tri hull made by Invader.I'm not familiar with this name.Where can I find some info about this company and are they still in business?
  3. O

    Just purchased 1974 boat made by Invader..where can I get info on this boat comp

    Just bought a 1974 Intruder 16' fiberglass tri hull made by Invader.I'm not familiar with this name.Where can I find some info about this company and are they still in business?
  4. O

    Have older metal 10 to 12 gal gas tank ...can I hook up sender and gauge for th

    I have an older model but clean metal gas tank on my boat.I just bought the boat and have not filled the tank yet.I'm guessing it's around a 10 to 12 gal. tank.It now has a gauge built into the top of the tank but it is broken and doesn't work.I was wondering if I could remove this old gauge and...
  5. O

    Want to install new water pump but lower unit will not seperate!

    1974 Chrysler 75 hs. 3 cyl. Model 757HA<br />Want to install new water pump or impeller because of no water discharge when running.It's been sitting for a while and the trouble I've had loosening the bolts and nuts and screws tell me that this unit has not been apart for a long, long time.Four...
  6. O

    Does my Chrysler Outboard have a Thermostat?

    I am trying to restore a 1974 Invader Tri-hull fiberglass Boat. It has a 1974 Chrysler 75 hs. 3 cylinder outboard.Model 757HA.I have had lots of ignition and fuel problems.After replacing the power pack ,points, plugs, fuel hoses and removing and cleaning the fuel pump and all three carbs.it now...
See more
Top