I have a 1976 Evinrude 75hp with out trim/tilt... I just found a 1979 Johnson power trim kit online, will it bolt up or are they different model years?
Thanks in advance,
Oldyota
Alright I acquired a 1986 Polar Kraft 16' aluminum fishing boat with a highlander trailer for free last year... I completely restored the boat and added a 1976 75hp Evinrude as well as a 24v trolling motor with 2 deep cycles...
I'm wondering about the tires and springs of the trailer...
Its a OMC 800 stringer outdrive with the hydraulic ram setup. Currently I can hit the button and it will run then stop mid stream, then it won't do anything until I turn the key off and turn back on... It does it while going up & down.. So it is working intermittently then just stops.. I can...
All I can say is that this is the best forum I've found in a long time regarding boats...
So here's my issue, I currently have 1976 75hp Evinrude on 16' polar kraft, but it has no trim/tilt... I've looked on ebay for a used one and all around here locally to no avail.... I know that this model...
So my prior post was on my 1975 75 hp about hesitation at WOT, so after re-cleaning and re-syncing the carb's the choke problem is fixed, but it is still bucking at WOT. So had my brother squeeze the bulb at full throttle and she ran fine. I have checked all of the fuel line and vacuum line...
Alright so my 1986 Celebrity 210V is getting lots of works done on her... I've ripped out all the rotten interior pieces and I have to re-build my engine cover and back seats. How much room do I need to leave from the top of flame arrestor/carb to the bottom of the cover? I was thinking about...
Alright I have old 75 hp Evinrude and it wants to die when start to give it throttle, so I push the choke button and it picks back up... Then when I have it on plane and give it full throttle and is surges back and forth, but at 3/4 it runs like a top.. I just got done tearing the carbs apart...
