1998 Evinrude 50 hp G04441075
I purchased the boat and engine new in 1998. The lower nor engine has never been apart. The engine may have 300 hours if that and is in pristine condition (or was). Three weeks ago my Dad and I went fishing. We left the dock and while under power I heard something...
Long story short, one of my customers overheated his motor thus melting everything from interior exhaust bellows, driveshaft and shift cable bellows, basically everything in the bell housing that was rubber. My question is on the speedometer tube, service manual 28 says to remove the inner nut...
2010 M3 with a PCM engine. Customer called me to go for a ride and listen to this weird noise and vibration the other day. I climbed on the boat and from about 2000 to 3500 rpm (the best way I can describe it) it sounds like a wiffle ball going through the air or a "flutter" if you will.
I...
2001 Chaparral MCM 350 Mag Engine Ser# 0M029132, Drive Ser# 0M107260. Gear oil laying in the bottom of the boat, from what I can see it appears to be leaking back through the flywheel housing, the line and fitting are dry. I removed the drive and the input shaft bellow was completely full. A...
Didn't have a lot of time to work on this Saturday going back today to try and diagnose. It's a 2003 Ebbtide with the 5.0 merc with the electric in-line fuel pump. The engine cranks fine but has no power to the fuel pump and the distributor is not firing. Ran fine the day before, checked the...
I just finished building an MCX for a Master Craft, I was told by a Master Craft mechanic that the timing needed to be set by cam angle (705 +/- 5). I plugged my laptop in yesterday for intial fire up and set timing, I have Diacom (which is what he said they used) 2.5 (newest version) and the...
