Besides loose steering my motor has issue too. It will not rev past 2K rpm's when on the water in gear. At first it did, say for 15/20 min it would run on plain and seemed OK. It had some breaking up at w.o.t. (4200 PRM) but other wise smooth cruising. Then I slowed to idle speed to attempt a...
My 1987 mercruiser Alpha 1 gen 2 out drive has loose steering connection. The two aft facing nuts ( boy thats a close one) near the top of the intermediate housing and seem to tighten the whole deal to what seems to be the steering arm, where and are tight. Meaning I didn't have to tighten...
What was a good running 60 hp motor just died on me and will not start. I have no spark on any of the 3 cylinders. I disconnected the (red) harness connector to Isolate the problem to under the hood and used a starter button. Connections within motor look great. My question is: My Clymer manual...
I managed to over tighten and break off the .015 Orifice connector part number 2374400 (brass break line adapter)on the master cylinder of a DICO SurgeOmatic mod 10. . My question is where can I get surge break actuator piece parts?