I just got the boat and the tilt/trim stopped going down. I checked the fluid and it seems low. The fluid is gold not red like I thought it would be. What should I put in it. Thanks
I’m looking a buying a 2009 seahunt gamefish 22. It has a Yamaha 200 four stroke with almost 400 hours on it. It does need new interior. Is there anything I need to know about this boat any known problems. Also what would be a fair price point. It has the standard electronics. Any help would be...
I’m looking for some opinions on this boat. I tried the search function first and searched the web and can’t really find any information on this boat. I did have a stingray 195 I thought was ok. I would like a little bigger boat. Is Caravelle and stingray almost on the same level as build...
Need some help on cutting for the steering arm on the new transom. The boat is a 1991 regal velocity with 454 and bravo 1. Not really sure how much to cut out.
Any help would be appreciated.
Hi,
Has anyone used this stuff if so what are your thoughts. I'm getting ready to prime and paint my cabin and deck. The boat has all new wood glassed in with epoxy. Any help would be greatly appreciated. I also tried searching on this topic I didn't really find much.
So I finished putting my deck down and I forgot to place the bottom pedastal brackets under the deck. Now I need some advice on how to mount my seats with out cutting a big hole in my deck. Any advice would be greatly appreciated.
I was laying the fiberglass cloth out for the deck but I'm short on 2 pieces there around 2 foot by 2 foot for the engine bay. Would it be wise to lay what I have now and finish it when I receive more fiberglass or should I wait to do a wet lay up.
I'm replacing my deck on my 24' cuddy cabin and just want to figure out if I should fiberglass under the deck also or should the epoxy be good enough. I'm using 1/2 inch plywood covered in epoxy and 1700 biaxial fiberglass.
Hi I'm getting ready to paint my new deck and looking for opinions on what paint to use. Has anyone tried both of these paints. I would be using tip and roll. If it matters I would be painting over epoxy.