Recent content by patmilstead

Want to use back mounted starter need 14 inch 168 tooth with ring on front flywheel. Does any one know where I can get one or what has to be done to existing one. Thanks Pat :confused:

Just replaced oil pump gasket and seal on 71c trans, reinstalled, filled with type A Trans fluid. when I engage trans forward or reverse it squeals. even at idle this did not happen before changing seal. Any suggestion out there?? Pat

Does anyone know where I can get a dipstick and tube for chevy 350 mid 80s stock engine for passenger side??? Thanks Pat

Help I need to change oil pump on 71c velvet drive/ Thanks for any help. The transmission is already on the bench.

Does anyone know if you can extend a VHF antenna cable. Can you by a ready made cable extension, can you solder more cable??? I know dumb question but I have a good antenna don't want to buy a new one. Thanks for the help Pat:confused:

Hello I have 25 ft Chrissy. I re powered with chevy 350 4 bolt main it has a velvet drive trans. 168 tooth 14" flywheel with a 2 bolt staggered bolt pattern. I have bought 4 starters now and none of them will fit. This bell housing has a mount on top and the one under engine. I want to use...

need to post question about engine problem

I want to use starter in bellhousing upper starter hole running velvet drive with chevy bellhousing adaptor. the existing is mounted down under and almost impossible to get to without removing a bunch of hoses and electrical. I have not been able to find the right starter. So Far I have bought...

Does anybody know where I can get a furuno 1621mk2 power cable. Furuno does not service this model anymore.

Please any body I have a Furuno 1621mk2 cables connectors went bad but the cable is good and its in a radar arch. I do not want remove the cable, as it is a big job. Does any one know where I can get new cable connections. knightrider

Please any body I have a furuno 1621mk2 the cable ends have went bad but the cable is good and its in a radar arch. I do not want remove the cable, as it is a big job. Does any one know where I can get new cable connections. knightrider

I have two force 125's I am going repower with. I have Seabird 23ft with chevy 350 and omc sterndrive being removed. I need all the information on transit beef up also should I go with one force 125 or two. Information on mounting brackets. I would like to know if transit can be cut to...