Hello,
I'm trying to purchase a Michigan wheel propeller (032021) from the commercial website. I can't seem to select shipping to Canada. In the drop-down list the only options available for "Country" are blank, blank and the United States. If I checkout with Paypal it almost works, but then...
For years now we've been using a hard, traditional antifouling paint on the bottom of my brother's Shark. Although it has worked very well, I'm getting tired of the sanding and repainting. We've been sanding down hard every two years and recoating every year.
Am I a fool not to be going to...
Does anyone know what fuses/circuit breakers are or are not ignition protected? I need to locate a 30 or 40 amp circuit breaker or fuse in a location that requires ignition protection, and I cannot find much information on the subject.
Specifically, I know of some pricey surface mount circuit...
I'm putting together a custom fuse panel. The front panel in which everything is mounted is clear plexiglass. I was thinking I could paint the reverse side white, then use rub-on lettering on the front side. Hopefully a couple coats of clear coat will protect the lettering and stick to the...
It looks like you reached a major milestone yesterday. Ten thousand helpful and good posts is a monumental achievement which speaks volumes about your character. <br /><br />I would thank you personally; I've learnt quite a bit about outboard repair from your posts. And more about setup than...
I ran into a problem today putting on the winter tires. The snow tires are on their own steel wheels so all I normally have to do is unbolt the alloy wheels with the summer tires and bolt on the winters. <br />But this year I have a new car, and the old steel wheels don't quite fit. The rear...
Well, I never really got very far with this project. All I have is a pickup stage that works off one of the magneto lines:<br /> http://tinypic.com/dfwnd4.gif <br />This gives me a measured signal like this:<br /> http://tinypic.com/dfwn4h.gif <br />The red line is 0v, the...
Is it at all possible? I've been able to get the tension even between the shrouds very effectively by sighting up the mast, and the inner/outer tension ratio by sighting up the mast while sailing. But I've noticed they go completely slack when enough backstay is put on so I think I'm not...
This topic was drifting a bit so I thought I would start a new post. I agree about those old style filters, so this is what I've done:<br /> <br />(the pump on the left is the later pump, just killing two birds with one stone)<br />Thats a short automotive carburetor fuel element I think for...
You're onto dragging up posts that are two months old. The conversations are long over. It's really annoying to us regular board users.<br /><br />I don't mean to come across as an arse, but I thought you should know. Current legitamate posts are getting buried quick by your last 48 posts!<br...
I have one of those little 5 gallon parts washers which I've only used those 'environmentally friendly' solvents in. To say the least, I'm not entirely happy with them. It seem to me to be painful to use even when wearing gloves as inevitably a little gets splashed occasionally. And once when...
I know you folks are busy with the everyday business of IBoats, but would you mind adressing this:<br /> Iboats thread, Click Here.<br /><br />Thanks! I and others need to know what the rules are now. Feel free to delete this post - I just wanted to bring this to your attention.<br /><br...
Somehow the tilt lock lever on my uncle's Suzuki DT75 got mangled. Probably from trying to operate the tilt/trim with it locked or half-locked. Here's what it looks like now:<br /> <br />I would like to bend it back into shape for him - good as new, but I really cannot figure out...
