Well, the hose on the bottom of the tank that feeds to the pump did come off. But I’m thinking that bleeding for this engine may mean to just run the motor on an external pre-mix and let the air run back through from the return line. Thank you.
The service manual only says to bleed but doesn’t explain the process. I do plan to run on a separate tank with 50:1, so maybe that’s all I got to do. Not sure why it won’t fire, thinking I flooded it or something.
Yes, I’ve seen that video but my pump doesn’t have a bleed screw. That one is older than mine. Plus my oil tank blocks access to the pump so I’m guessing bleeding might be accomplished some other way.
BLUF: How do I bleed the oil injection system on my Yamaha 60tlrc 2 stroke?
I was planning to go fishing and was topping off my oil injection system. I grabbed the Yamalube and started to pour when I realized it was the gear case oil so much heavier. It wasn’t much but I thought it best to dump...
Hello, I just picked a used Minn Kota Riptide Powerdrive 12V 55 pound thrust to replace an old motorguide 46 because I don't like the cable foot steer.
It will being going on my g3 pro 175 and Minn Kota says I should use 4 gauge wire for the length so I bought 4 gauge marine wire.
Question...
Motor: 1986 Johnson 6hp on a 12 Jon boat
Model: J6RCDE
My motor is running like it is rich, carb clogged, won't throttle up all the way, etc.
The history of the motor. I bought it a few years ago from a guy who had it in his garage for 20 years without use. It looked brand new, fired up and...
I have had this motor (1986 Johnson 6hp) for a few years. I purchased from a guy who bought it twenty years earlier but he never used it. It looked brand new.
My problem is I was driving my boat and I went to slow down to grab my catfish jug and it just died and I couldn't get it to start. I...
