FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I am replacing the seals on the prop shaft... the lube is milky and leaking out.
what other seals should I replace to ensure that lube chamber is waterproof?
Sorry to keep bugging you guys... I do have a manual on order.
anyhow, how do I replace the prop seals on a 1970 100 hp outboard? mdl 100193 c
The parts place tells me there are an outer and inner seal plus an O-ring... about $25 for all three seals.
Well, I just finished cleaning my carbs.... and they were pretty clean to start with.
however in my efforts I did discover how the manual choke button works! I had it set so it was flsuh with the engine cover body.... it could go either in or out from there. Out is full choke, where it was is...
I have a 1970 Evinrude 100 hp outboard engine. It has sat for the last five years and I just purchased it.
Out on the lake this weekend the engine would stall if I was operating at a higher RPM for more than a minute or two. Maybe about half throttle or so.
Full throttle was only producing...
I have a 1970 Evinrude, 100 hp outboard. First time out with it today and as long as I kept it at a low rpm, all went well. But as soon as I gave it the gas, even moderately I could hear the engine come out from being under load and the prop would barely spin.... not forward or reverse. Even...
