Recent content by PGibbons99

  1. P

    Bent Push rods - problem solved

    Well I found out the problem on the bent push rods. The machine shop that did the valve job installed the wrong valve stem seals. They used umbrella seals that were about 1/4" thicker than the original seals. Thanks for the replies.
  2. P

    Bent Push rods

    1999 3.0 SG Volvo/Penta was run hot because of bad water pump. I pulled the head and found a blown head gasket. I had a valve job done on the head and replaced the head gasket,thermostat, water pump, flapper valve, and flapper boot. I installed the head and adjusted the valves to the correct...
See more
Top