Recent content by Piedog

  1. P

    1984 Mercury 75 Hp tach harness!

    Ok I have figured out my tach harness, but my tach still doesnt work, can someone tell me where the grey wire goes to on the motor, I havent been able to find a wiring diagram on the net so far.
  2. P

    My Tach Dont work!

    Could someone please help me with this , my tach doesnt work , is there a way for me to check it and see if it is good or bad ! When I turn the key on the needle on the tach moves just a little and then settles back at 0. Thanks!
  3. P

    1984 Mercury 75 HP with tilt/trim. Tach Harness Question

    I have a 1984 Mercury 75 Hp with tilt/trim My tach harness has 5 wires coming out of it , can someone please tell me which on goes where??? Purple....... Grey with blue stripe....... Brown with white stripe...... Blue.......... White........ Does anyone know or have a wiring diragram on the...
  4. P

    Help please! 5 wires

    I have a 1984 Mercury with Powere Tilt and Tirm , its a 75 HP. The serial # on the motor is # 6559348 and the Controls have the words QuickSilver on the side of it! My question is there is a plug on the front side of my controls that goes to the dash that has 5 wires coming from it. the wires...
  5. P

    Transom and stringer replacement!

    Could someone please give me an answer on this. I have under taken replacing all the wood in my bass boat. the question I have should I coat all my wood with the epoxy risen before I fiberglass them in , meaning the floor both top and bottom and the stringers and transom!
  6. P

    Complete rebuild of a 84 Challenger Pro

    I am doing a complete rebuild of a 1984 Challenger Pro . I am asking for some help on here! All my wood is good that was used as the live well covers , dry box cover and etc. my question is should I when covering them back with new carpet . Each door have a piece of plastic on the bottom side...
  7. P

    Tilt/ Trim problem.

    I have a 1984 Challenger Pro Sport Fisher with a 1984 75 HP Mercury on it. Can someone tell me why I can not tilt or trim motor while going down the lake? When I am setting and just in idle it will do both but one I take off it will not work. Thanks for the help.
  8. P

    How to check gages!

    Can someone tell me how to check the volt, tach and fuel gage to see if they are working or if there is a problem with them!
  9. P

    NAV/ANC Switch question!

    I hope someone can help me, I know that the Nav/Anc switch is a on left off middle and on right switch. I also know that when the switch is to the left on Nav , my dash lights work and both my front light and back light work now my question is what should work when the switch is in tha Anc mode...
  10. P

    Wiring Question!

    I have a 1985 Challenger Sport Fisher Pro that I am doing a little restore work on. my question is at the bow of the boat I have some controls on a plate . 1 is the plug for the trolling motor which I think is either 12/24 volt and 3 switches 2. from right to left there are 3 switches . First...
See more
Top