Recent content by pigety

  1. P

    Volvo SX Shift Shaft Seal Replacement

    Hello. I'm working on re-sealing my SX drive. In order to replace the shift shaft seal, the manual states to use a punch to drive in a retaining pin in order to remove the klevis pin. Unfortunately, the retaining pin only went in part way and hit a hard stop before it released the klevis pin...
  2. P

    Johnson 9.9 Running Rich at WOT

    1992 Johnson J10RENA--what's the main jet diameter supposed to be? I bought this motor used and I'm wondering if the previous owner tried to "modify" the 9.9 carb to a 15 by changing the main jet. The motor runs good at idle up to ~1/3 throttle and then starts to run rich. Read my previous...
  3. P

    1992 Johnson 9.9 Won't Run Right

    Hello all--kinda long post, but I'm stumped. I picked up a Johnson J10RENA of off Craigslist for $200. It had been sitting for several years, but looked good. So far, here's what I've done with the motor: -Carb cleaning & rebuild with oem kit. The carb was filthy, but I've managed to get it...
  4. P

    Antique Johnson JW-10 3HP Restoration

    Hello all. Much time lurking, first time post. I've started a restoration project on a Johnson JW-10 3HP outboard. I've found carb kits, head gaskets, impellers, etc. already. Is there any resources to get additional engine/lower unit parts? The cylinder walls are slightly scored and should...
See more
Top