i have a one on a Tracker Pro17 boat. OB serial # is 0G223601 for ref.
it has been setup for a year or so since last run. i know i need a water pump kit. it also is leaking water around the end plate on theh #1 and #4 cylinders just below spark plug.. it is putting a good stream out of the...
i have a 95 40hp Mariner on a Tracker Pro 17. it has been sitting up a while. i put a brand new fully charged battery in and hooked it up. turn the key and nothing. it would just barely turn and made a squealing dragging noise... so i definitely think it needs bearings. whats your take on this??
i have a Tracker Pro17 with a 40hp.
?1 the trim switch on the shifter is not working properly.. it will trim the motor up but not down.. the bow and motor switches will trim the motor up and down.. the problem in the shifter switch or connection somewhere??
?2 the tach is not...
i would like to open up my rear seat up and make storage out of it.. pretty easy i know but it has foam blocks under it.. will i need to add some foam to it?? i plan on making the center of it into a either storage or a livewell.. would this be too far back for a livewell??
boat is a 1975...
can anyone tell me where to find a wiring diagram for the trailer harness?? its a 95 w/ 5.8l. it has the factory tow package and 7 round harness but the harness was crushed and not usable.
i have a 1975 Evinrude 25hp. i melted the wiring going to the solenoid and electric choke. the electric choke is toast so i chunked it.<br /><br />my solenoid has 4 posts on it. 2 big ones that go to battery and starter. the too small one?? marked I and S.. i have just a standard push button...
my electric starter on my outboard is runs but very slow. i have a good hot battery with a charger/booster hooked to it.<br /><br />how do i check the started?<br />how do i check amp draw?<br />how do i check voltage drop?
i have put a front deck onmy john boat and attached it with screws but now want to seal the edges to the sides fo the boat to make it more water proof. i have never done in glassing before so not sure what is good and bad..<br /><br />i was wondering where you can find the cloth and resins?
i was wondering if i had to use thru-hull fittings in the catolags like cabelas or bass pro?? could i use some for the poly tanks like ona spray rig.. they look the same just a little heavier built and thicker gaskets..
i would like to add a steering console (with sterring wheel) to a boat. what is the best way to do this?? i have thought about makin it out of wood.. is this a good idea.. i would rather have one out of aluminum but dont have anyone to weld it up or into boat. i would like to put a live well in...
