FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
When I turn on the ignition I get a short beep and the lights come on and go out one by one.
If I short the tan wire to ground, the overheat light comes on but no sound is heard.
I have installed a CDI 113-6292K 1 power pack on my ?02 90hp Johnson and am trying to set the timing per CDI instructions. I am using a remote starter switch to crank the engine. I have disconnected the port timing sensor Tan and White/Black wires and grounded the Tan wire. When I crank the...
Has anybody heard of a charge or power coil going bad?
I suspect that I have a problem with mine but don't want to spend the money if they never fail.
Thanks,
John
I have an intermittent problem:
When it happens: I can put it in gear but when I advance the throttle even slightly, the engine stalls. I can restart it but then the same thing happens. If I leave it in neutral I can rev it up and then when I put it in gear it's OK for a while.
My thought...
This happens frequently but not always.
Starts and idles OK and will go into gear without stalling but when I advance the throttle it dies. Will restart without problem.
Sometimes it will run fine for 15 or twenty minutes and then will just die when moving along at about 2500 rpm.
When it...
I have no spark on any cylinder.
I have the factory manual and it says (pg 111) to disconnect the port Packard connector and see if there's a spark now and there is.
The manual says the problem is in the stop circuit.
It then says to check the black/yellow wire to ground with an ohmmeter. I...
