Ok thanks, just installed a new (used) complete armature assembly and new* rectifier. I had this problem originally, I'll trace all the wires out for breaks and bad connections and test the stator
So I threw a new rectifier on there, the voltage slowly (very slowly) climbs up. I'm in the driveway with muffs so I'm not throttling it up too much. I watched a guy on YouTube with a mercury check with his meter on the battery and as soon as the motor starts and levels out his voltage climbed...
So I reassembled with new armature plate support and bearing and it only took out about half of the "slop" and still rubbed bad. So I ordered a used complete armature plate assembly and now there's no play at all. It appears to be cast aluminum I think with a brass bushing in the center and the...
I already ordered a new support plate and bearing, with the amount of play between the two this should solve the issue. I don't quite understand what you're talking about with punching the boss in the specified locations. As long as I don't have a bad crank shaft bearing this should solve the...
So I'm having what I read to be a pretty common problem with the flywheel rubbing. I've been having what sounds like a bell ringing noise from the motor. The support plate and bearing for the armature plate is worn really bad. It was actually popping the linkage off from the throttle to the...
I'm interested in purchasing a Hydra Sport 180cc from someone who's asking $9000.00. The boat is in really great shape and has an Envirude 115 etec 2 stroke. Not sure of the hours yet as I'm going to check it out and test drive in a few days. If anyone is familiar with this model boat and motor...
I have an 88 Sylvan Pro fisherman 16' aluminum boat. After a recent outing in some rough water my pass through windshield became separated and came through past the other windshield it rests on. I was able to flex the consoles and pop it back through but now the mark on the aluminum where it's...
