My switch was worn down and I obliterated it in the process of trying to reposition it. I am having trouble tracking one down. Any help?
I need the complete 3 piece assembly. Unless there is another option to safely start my motor.??
my motor is an 86 4hp evinrude.
http://cgi.ebay.com/ebaymotors/NEW-FUEL-PUMP-FOR-JOHNSON-EVINRUDE-6-8-9-9-15-HP-PRE93_W0QQcmdZViewItemQQ_trksidZp3286Q2ec0Q2em14QQhashZitem3ef8687446QQitemZ270455567430QQptZBoatQ5fPartsQ5fAccessoriesQ5fGear
looks just like the one in the link. thanks
Just recently I took out my johnson and whipped it around the reservoir on a fresh batch of fuel and the motor started smoking. I ran it at about 32 to 1 and towards the end of the 1/2 mile jaunt it began to start smoking a little.
I didn't think anything of it and just chalked it up to a bad...
Just recently I took out my johnson and whipped it around the reservoir on a fresh batch of fuel and the motor started smoking. I ran it at about 32 to 1 and towards the end of the 1/2 mile jaunt it began to start smoking a little.
I didn't think anything of it and just chalked it up to a bad...
well I'm cleaning up my motor. right now I'm trying to split the block in half at the cylinders to see what the inside looks like. I guess I don't know what I'm looking for , but the cylinders seem smooth and have good compression. Anyways how do I split it in half. do I just take a flat head...
Just looking for a shear pin. I went to napa but they don't carry it.
i'd like to order one online. the problem is most places don't call them shear pins and I don't know the other name.
anyone know where I can get one?
thanks.
sorry for the overload of posts this morning. im trying to...
I'm having trouble with removing the flywheel.
actually I've never really been able to do it. I bought a harmonic balance puller. swapped the hardware they gave me for grade 8 steel but still can't seem to pull the flywheel off.
everytime I do it the bolts get crooked. Is there a way to make...
well finally got her running today. sounds awesomeeeeeeeeeee
anyways troubled to find out though that no water was being pumped.
this isn't air cooled is it?
otherwise I'd have to assume it was the impeller no?
btw.. i have another post about this motor but i thought if i asked this in...
just wondering if the float pin comes with that wire that attaches it to the arm.
I don't think it does because when I removed the carb it wasn't there.
I'm having trouble though figuring one thing out. does the rubber tip go up through the hole in the bottom of the carb or does it rest on the...
I pulled my carb apart to unstick the choke that was froze and now I have no clue how to set the float level, and really I'm pretty in the dark all together. I took a few days to figure out how the choke assembly works, but until I know how the pin is held in place, I'm stuck.
I did get some...
i have a general question here.
im trying to reassemble the carb and im stuck because i am not sure which way the float pin rests on the metal arm that connects the float to the motor. i am assuming that the pin should go rubber up. meaning the rubber tip should point up into that fuel port...
