FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
My motor seems to die while its running at any speed and the primer bulb keeps going soft in fact its hard to even get it firm . I was wondering if it was the bulb or the fuel pump . It will stay running if i keep priming it but a few moments after I stop it dies . This happened on my 50hp a...
I can't seem to get my motor to tilt up . The lock seems to release from the tilt lever but I can't get it to tilt up . There is nothing in my manual that shows how to repair this . Any help would be appreciated .
When I reinstall the flywheel after replacing points and coils do I need to worry about the timing marks on the outside of the flywheel or can I just reinstall the flywheel .
ok here we go . I have a strong spark will jump a 1/2" gap upper cylinder 150 psi and lower reads 140 new fuel pump last fall carb kit last summer as well as tank and hose . I can get it to "start" if I pour fuel into the carbs but it won't stay running . So I don't know if I should take an...
OK where to start . I have strange problem for me anyway I can only get it to start i take a plug out and squirt fuel into a cylinder after that will run fine. I just replaced the gasket for the fuel filter (cause of soft primer bulb) new plugs and coils as well (rotten wires) I set the gap .030...
