Recent content by PW1967

  1. P

    2 stroke vs 4 stroke

    I figured I would post this question in this topic due to its not a brand specific question. I am looking to purchase a bass tracker or similar brand in the 2007 to 2013 era, and see that some have 2 stroke and some have 4 stroke, Bass tracker usually have mercury while other brands have...
  2. P

    87 force 50 starter wont crank from key

    OK I'm at the end or my rope on this one. 1987 Force 50 on 87 bass tracker. I have no 12v. power at the ignition switch, all accessory work but that's on a different circuit. I can basically run a jumper wire from battery directly to solenoid and engine will crank and start. but will do nothing...
  3. P

    1987 force 50 chip in crank

    So is this something I should be concerned with, or anyway to fix it without removing or replacing crank. it happened do to a loose flywheel.
  4. P

    aluminum boat patch

    just looking for some ideas how to finish this,(pics enclosed) The P/O jabed two holes each side of keel, and made these patches, leaked alot, I pulled patches and sealed patch plates with marine grade JB weld. and used 3M marine grade silicon on rivits. It still seeps a little water, maybe...
  5. P

    annoying oil leak

    I have a 260 mercruiser that sits in a 1985 sea ray cuddy. Ive been trying to narrow down a engine oil leak that leaves a mess in the bilge after a day out in the water I added some dye to oil because I just could not find it on a black engine. It appears to be dripping from behind of the oil...
  6. P

    force 50 ignition issues

    II was attempting to wire in a hot wire for a fish finder and had to pull my ignition switch out to gain access ( 1987 bass tracker with 50 horse force C model) well I pulled a couple wires loose pulling on it. and my safety lanyard wires had bad connections so i just disconnected it. I did not...
See more
Top