Please could you confirm the correct plug type for my 1972 18hp Evinrude. I've just bought some Champion J6C's but they seem to be a shorter reach than the ones that are in it already, but that's not to say the ones that are in it already are the right ones! I don't think any damage has been...
Please don't think me completely stupid but, how do I adjust the float height on my 1972 18hp evinrude, I've just installed a plastic float and its not parallel. The obvious thing is just to bend it!<br />Lee
One of the good people in the forum mentioned that you had made some trim tabs or an aft board for your boat. I am about to do the same and would really appreciate any advice you could give.<br /><br />Lee
Hello, <br />I've an old Avon Inflatable (not rib) that's around 16' And I have an 1972 Evinrude 18hp on the back (tiller controlled). I know I could do with a bigger motor etc, but frankly I only use my boat a couple of times a year on holiday and I don't want to put any more money into it. I...
Hi Guys<br />I've got an old 'rude 18hp I don't know the year but the serial no on the clamp is: 18202rc78793. my real question is:<br />together with my father we have rescued this motor from the scrapheap, it's got a fresh coat of paint and looks superb however it dosent go all that well. I...
Hello all, not been on for an age.<br />I'm in the process of rebuilding an 18hp 'rude and I've a couple of questions.<br />What should the points gap be?<br />With my dad's help we've stripped off the lower leg to replace the impeller and disconnected the gear change linkage about halfway down...
Hello from the UK.<br />I have a 7.5hp Evinrude from around 1981 which has a electrical connector on the left had side (if you look at the engine from the back) is this a charging output, if so does anybody know the rating? thanks<br />Lee
