Recent content by R1racer

  1. R

    98 200hp No Techometer reading at lower speed.

    Hi ..Its a 98 200 HP , Took it out today for fishing trip , It started OK ,At the dock i did not pay much attention to the Tech reading , It usually turn950-1000RPM at neutral . Got it on plain and reached 4000RPM. . On the way the Fish finder flashed High voltage detected and the finder shut...
  2. R

    Why My evinrude RACE at Idel

    I got 1998 Evinrude 200Hp 90 degree laitly it got my attention to few things that not sure about so I need some thoughts and Help , first of all the Eng start right up great and idle using the hose @ 1200-1300 RPMS but never slow down to like 1000-1100 after it gets warm compare it to another...
  3. R

    Will this prop setup risk my Lower Unit

    Re: Will this prop setup risk my Lower Unit Here is the new Thrust washer and the OMC thrust washer you will see the difference ..
  4. R

    Will this prop setup risk my Lower Unit

    I got 200hp Rude that we need to mount a Power tech prop part # Un200 Rh 3 blade which is universal prop /hub 15 spline thru hull exhaust, prop fit right on the shaft, However it didn?t came with the hardware kit (Thrust washer, spacer, Lock nut) But I received the instructions only with it ...
  5. R

    Power Tech SS Prop

    Does any one know where could I find the hardware kit # UN0 for this prop part # UN200PTC3RJ7P so it could be mounted to Evinrude 200hp V6 15 Spline Since you cant use the OEM hardware with this prop Or better yet any one got a Pic of this mysterious set up (thrust washer, Spacer)..? Thank you
  6. R

    What am i MISSING

    1998 200 Hp Evinrude .. I got 2 tanks on 24ft WA , Was out the other day using my spare/AUX tank 38 Gal and noticed at WOT i received auditable loud alarm with check Eng light.. Turn boat off and start again give it gas but no alarm at Mid -low speed Though it was old fuel or some dirt got to...
  7. R

    Is this sound right

    Got an 1998 Evinrude 200hp on a 238 WA Neptune sunbird that hanging of a platform, RPM @ WOT 4900 with top speed 42MPH GPS reading, I know Eng should be 5500RPM at WOT, My Michigan prop rapture SS size which came with the boat 14.25x19, SO i called one of the local dealers around they said am...
  8. R

    Evinrude BRP/OMC 2+4 fuel conditioner

    Has any one used this product before... I was at my local dealer and they highly recommended that stuff to condition the fuel much better than Sta-Bil Marine I add STA-Bil Marine to my Evinrude 200 ,Never used any other product so figure to check what every one else think
  9. R

    1998 Evinrude 200 Hp Want stay idel

    Got boat out today after been setting for a month but I start it every week, This will be the 3rd trip since bought the boat, Last trip had 70 miles round trip without any trouble, prior purchase It got full inspection by the marina and few items were replaced and repaired, I installed new fuel...
  10. R

    Need Some Help With 70HP Evinrude

    I got 1986 70 HP Evinrude that dies when i shift forward but idle fine and reverse fine , When i shift to shoot of the hole it dies unless i slam it in full throttle it goes but some time it get a hiccup and die, When it goes I can back off the throttle then i will stay running around 3k RPM...
  11. R

    Help with 1986 Evinrude 70HP

    Hello every one , am looking for some help.. I got an Evinrude 1986 70 HP that been sitting for couple of years, At first she start, Shift while on the hose &idle great. Out at the dock under a load she runs but as soon you shift in gear she dies immediately. I use 6Gal fuel tank, am using a...
  12. R

    Fuel system /VRO pump question

    We got 1997 Evinrude 130HP , We took it out yesterday after I changed the plugs to see how it runs, It ran great all day on WOT with no problem, Pulled in to fish for 45 Minute ,At first it started up fine but died on me then it took way longer to get it running, Then it started back up when...
  13. R

    Shift cable want engage

    I got 1997 Evinrude 130Hp on a 20 sunbird, I took out this AM start right up let it warm up ready to take off but it want engage either forward or reverse, Loaded back and went home bummed out, I disconnected the shift cable from where it mount to the arm that connected to the shift link to...
  14. R

    Fuel stabilizer for Evinrude 130hp & Marine Eng

    Just carious to get the Marine expert opinion on adding fuel stabilizer to my fuel tank , I used this product in all my race application , it never failed me in any way, I ran it on EFI and CARB application Cars & Motorcycles , Would like to get the Up's and Down's . As I personally wouldn't...
  15. R

    1997 130 Even help /tips needed PLEASE

    Hello Every one ..Am new to the forum and to the boat world couldn't find any other place to seek help but here . So am glad to come across this place and join the happy boater world ... I just bought my 1st boat Sunbird Neptune 201 with 1997 130hp 2 stroke 4 carb v4 . Here's what am...
See more
Top