This just happened. When we shut off the engine a little bit of gas will drip out of the back the motor through what I believe is the exhaust. Has anyone had this issue. Some people have told me it is the carbs but this motor does NOT have carbs. Fuel Injected. Thank you!
I have people telling me to use yamalube. Don't use yamalube. Use Amsoil synthetic. Don't use amsoil. This is a 4 stroke motor
Our family got back into boating this year and I want to use the best lubricants. I did call yamaha direct. The gentleman at Yamaha told me it did not matter...
It is a very nice boat. I wasn't sure at first but what a nice boat. NO carpeting except on the sides of the boat. I can't say enough about the fishmaster. I had posted a question earlier if you can put a swim ladder on the back of the boat. You most definately can
looking at buying this. It is in great shape but I don't really know anything about spectrum. Any knowledgable opinions would be greatly appreciated.
thanks,
bruce
After the carb rebuild and coils. (no plug wires) I ran it in a bucket of water idling. Started on 2nd pull and purred lilke a kitten. So far so good. I took it out on the lake today and this is what I have. runs pretty rough. I pulled the choke out when runnning and it wanted to die...
I am redoing my carb on a 1959 18hp seahorse. Awesome motor. The new packing (red) is loose on the needle jet. I can't tighten the lock nut enough to get a snug fit. I ended up putting 2 new red packing and 1 old black packing on the high and the slow needles to get that snug fit...
First of all let me thank everyone on this board who take the time to share their knowledge to help some of us who aren't quite sure.
I am rebuilding my carb with a sierra kit. The old packing for the low and high jets was a nice tight fit. The new red ones don't fit so snug on the...
This motor runs great once you get it running. It is a bear to get started. Any ideas would greatly be appreciated. We have already replaced the cracked coils. Made a big difference but it is still hard to start.
Thanks so much for any ideas
bruce