I have a 1984 OMC 3.0 sterndrive that I suspect the trim motor has gone bad. It is the gear driven Selectrim. The engine is in a deckboat and luckily I have the interior being recovered so access is pretty good. My question is this...Can the trim motor be removed without romiving the selectrim...
I am trying to restore a 1984 Hurricane Deckboat and have had fairly good luck finding parts until now. I am trying to locate the 2 drains located in the bow of the boat. There is one on each side just inside of the carpet. These drains go thru the floor to the hull but are only about 3 inches...
I purchased a 21' Wellcraft w/ twin 120hp I/O Mercs back in December and was trying to get it ready for warm weather and I noticed the outdrives do not go all the way up or down. One of the trim pumps was replaced and probably wasn't bled. Question 1 is what is the easest way to bleed the...
I recently purchased a boar with twin stern drive engines. The boat came with 2 hummingbird depth/fish finders. The transducers are mounted on the bottom of the transom. I have read that this is NOT a good location because of turbulence. Where is the best place to locate these. :confused:
I recently purchased a 74 Wellcraft Nova with twin 120HP Mercruisers. The person I purchased it from stated that both engines rotate clockwise and that according to Wellcraft it is the correct factory setup. Is this true? Also how can I determine the year model of the engines and ODs.<br /> :o
