Recent content by REBEL3068

  1. R

    Center toon shorter

    Thanks
  2. R

    Center toon shorter

    Figure better ask before I go any further. Got 22ft Bennington tritoon with honda 150. Got beat against dock during a storm. So changing outside toons. Toons are same size, 25". But brackets on new toons are taller than old ones. Did not realize until mounting last one. So outside toons are 1 to...
  3. R

    Moving 3rd toon back

    Dang that's alot of gas for not much speed. I git a 24ft center console that runs 64. If I want speed guess that's the boat. I just figured another 10mph on the toon would be nice. But doesn't sound like that is easily done. Thanks
  4. R

    Moving 3rd toon back

    No they are round all the way
  5. R

    Moving 3rd toon back

    How much affect will lifting strakes have on this boat
  6. R

    Moving 3rd toon back

    I tried several props until I found one that runs round 30mph and still takes off fine. But that was all I could get. Have it bolted in top hole and does not run out of water in turns. I know its not gonna run no 50 or anything. But I had a 24' pontoon with a 115hp Yamaha that ran 27mph, I just...
  7. R

    Moving 3rd toon back

    no lifting strakes all 3 toons are same diameter and lemgth 25" rear of boat is running 6" lower than front thanks anything else will be glad to answer
  8. R

    Moving 3rd toon back

    Have a 2006 Bennington 22' tritoon with Honda150 4stroke. Its runs around 30mph. What I was thinking of doing, and would like some opinions before jumping in it. If I move the 3rd toon back, would it increase speed. All tritoons I see the motor is back farther than the other toons. I can go back...
  9. R

    Jackplate on a tritoon

    I just bought a 2006 Bennington 22'triton with 150 honda that's has top speed of 32mph The motor sits back in a box and when I raise it to go into shallow water it's hits top of box and scuffing motor and upholstery If I put a 12"jackplate on it, it would get it back far enough to eliminate this...
  10. R

    Please recommend a jackplate for Kenner boat

    I have a Kenner 2103, 21 1/2 ft bayboat, with a Mercury 225 offshore that has been built up a little. Right now I am running 58mph at 5600 rpm. My hole shot is weak but when I drop pitch I lost alot of topend. How much more speed and gas mileage will a jackplate give me or would it even be worth...
  11. R

    taking apart a kenner center console

    i bought a 2005 kenner 21' vision center console that was hurricane damaged, i need to split the hull from the deck to wash out the silt and check the gas tank i got the transom glue cut out and the back will come apart & the front will come loose but the center will not, is the deck glued to...
See more
Top