Recent content by recce43

  1. recce43

    need ignition wiring diagram for my evinrude

    Well i broke my key ignition on my boat so i bought a seadog ignition wired it up nothing works no power or anything befor i could start the motor with broken one so i put it back in ...Guess what nothing works..
  2. recce43

    new to me

    Picked up this thunderbird boat trihaul with 200xp on it also have 4hp merc for trolling
  3. recce43

    vro fuel fitting?

    broke vro fuel fitting on my 87 200xp un able to find the fitting any ideas
  4. recce43

    vacuum switch

    can i run my 1987 200 xp with out vacuum switch?
  5. recce43

    crappy day

    well was goining to put new fuel lines on then snap broke and broke the fuel in line to the vro and the vacuum switch conection . im not able to find any replacement part for vro ..... And was wondering if i can run motor with out vacuum switch? aAny ideas where i can find vro parts the rebuild...
  6. recce43

    evinrude 200 xp 1987

    Well was out with new to me boat ran find then the issues started popping up. Loss of power and using fuel like it was going out of style. Found 5 of the 6 carb floats had black stuff in them so th floats was over flowing with fuel. Took them all a part cleaned them . boat ran great for two...
  7. recce43

    Just bought a cathedral thunderbird 18ft

    bought a cathedral thunderbird boat with 200xp evinrude on it trying to figure out the year of the boat Serial#AP0748
  8. recce43

    1989 110 vro evinrude stalls on idle

    well i had high speed issues used seafoam now the it runs great at high speed just can,t seem to idle it stalls out tried idle screw any ideas would help
  9. recce43

    are these covers towable

    do you think this cover is towable at highway speeds
  10. recce43

    1989 vro 110 rebuild or not

    is it worth to rebuild cylinder? cost much can a handy type person do this themselves?
  11. recce43

    110 evinrude bogging down

    :mad:vro 110 1986 worked fine all day 5200 rpm did some slow trolling then opened it up worked good then at the end of the day did some trolling then i shut down and drifted when i started it up only give me 3000rpm full throttle fuel blub has hard any ideas
  12. recce43

    evinrude bogging

    vro 110 1986 worked fine all day 5200 rpm did some slow trolling then opened it up worked good then at the end of the day did some trolling then i shut down and drifted when i started it up only give me 3000rpm full throttle fuel blub has hard any ideas
  13. recce43

    out board vent screw

    Iam not able to remove vent screw from lower unit . any ideas? It will not budge
  14. recce43

    ready to go

    worked on my boat on the weekend nice weather. But now we are in a snowstorm and its opening day on the lake:mad:
  15. recce43

    what a Day

    well new boat for me and the trailer needed work on it so jack up the trailer with boat on it.. Remove old axle.. Then everthing went to s____ . all the old axle is 59.5 inches don,t make that size here any more so new one is 58"... all the bolts on leaf spring where rust so bad had to cut them...
See more
Top