I know this is a stupid question but please bear with me. When you install a water pump impeller, what happens if you turn the rubber impeller fins the wrong way? Will they right themself? The reason I am asking is I put a new water pump kit on my 1990 Evinrude 200 while i was preparing to put...
The throttle body of my 2000 135 johnson has 4 adjustment needles. when cleaning the carbs each one of these screws was out from 4 to 5 1/2 turns. what should be the initial turns out from being seated to start fine tuning them. what do I "look"? for as far as running quality adjusting these...
Con someone tell me what the idle timing should be for a 1999 Johnson 135? What should the wot timing be also? I have the sync and linc procedure but my manual does not say what the Idle and wot timings should be. I think the idle should be 8 deg atdc +/-1 deg and the wot 18 deg +/-1 deg is this...
Hi all, I am adding a water separator to my 2001 Johnson 135 and need to know if I should put the fuel primer bulb between the tank and the separator or the separator and the motor? Any recommendations?
Thanks in advance
In going to replace the water pump on my Johnson 90. I dont know what year model it is though to order the pump. The model no is J90TLC05 and the serial is J6145363. It has a vro but I dont use it and just premix. Can anyone tell me what year model this motor is? Does it have the waterpump...
I have a 1980 135 HP V4 Evinrude and want to do a water pump job and all the bolts are out but the lower unit wont drop I have the 4 bolts out, the one under the trim tab, and the shift rod is disconnected so I think the drive shaft spline is rusted to the crank. This motor has had allot of salt...
Posted with a cutting out problem on my 1990 XP200 a couple of weeks ago (post name L77VJC4 vs QL77VJC4) and I was told to replace L77VJC4 w/QL77JC4's going to give it a try this weekend. What should I set the gap for? I premix 50:1 (vro unhooked)
I have a 1990 Evinrude XP200 and use L77V-jc4 plugs and gap them at .35 what is the diffrence between L77V-jc4 and QL77V-jc4? Is ther anything wrong with running the L77V's? Also after my first outing this year I started having a problem- above 4000 rpm the motor will drop out just like a no...
