Im still wondering what other models a 1982 lower unit from a 40 hp will fit. If you want to see a picture of it follow this link http://home.bellsouth.net/p/PWP-brentsbox Its in great shape and has a brand new water pump and impeller and I dont want it to go to waste.
I have a 1982 lower unit from a 40 hp and am curious as to what other models it might fit. If you want to see a picture of it follow this link http://home.bellsouth.net/p/PWP-brentsbox I have posted it on a site called FreeCycle.org and just want to make sure that the person that ends up...
I just got this motor from a realitive and have rebuilt the carbs and its running great. Unlike my old Mercury it does not have a tell tale. I have started it in a test tank and water sputers out of two slots high up on the back end. I am assuming this is the only way I know that the impeller...
I am rebuilding my carburetors on a 74 50HP and I liked to never got the orifices out. I had to file a small screw driver down to fit and the slotted side of the orfice got a tad bit chewed up getting them out. How critical is this or should I replace them?
I am rebuilding my caburetors and because there were not running good to start with when I got the boat I dont know if the prior owner had messed with them our not. Can someone tell me what the initial setting is for the low-speed needle valve?
I am rebuilding my carburetors on a 74 50hp. I have a Clymer manual and it says I need to use a float gauge to get the float level correct. My question is, how critical is this and if so where can I get one of these gauges or is there an alternate means?
