Hi all well I have to reach out to the professionals on this one, I have a 1995 johnson 150 fast strike which I am the 3rd person to work on ( not a good Idea ).
compression 105 to 110 on all 6
I recieved the boat and it would just flat out not stay running and if you did get it running it...
I have an o3 75hp merc ran great then the crank case hose which run to the fuel pump split replaced hose, may or may not be related. All of a sudden the boat will only run 3000 rpm at wot under load ( motor is on party barge) there is no misses or hesitation but will only get 3000 rpm. Now if I...
Boat ran great yesterday pulled out tpday hose split from the full pump to the block replaced hose now boat will only run 3000 wot under load but will run 5500 on fast idler
74 tilt n trim modle 135489 b
I just wanted to take a shot in the dark and see if anyone had the O.D. of the orings used in this unit. I have found the 2 cylinder kits ( brp ) but I have not found the orings for the shuttle valve manual release and the check valve, I have contacted BRP and it...
I have a 135 hp ev (1974) Im currently building a an 1872 flattbottom river boat. I need some advice on wich gauges to place in my new consold Im building, sofar I have got my tack, fuel, been thinking about a speedo but Im real iffy on that one, so what else
water temp
volt/amp not sure on an...
hi everyone I have a few questions that I hope you all may be able to help me with.
I have a 1974 modle 135489 b s# j000140 9 I bought a boat recently for the hull and it had this motor on it. The original owner of the boat had re wired the tilt unit and place a different hydrolic line on it...
i have a 1980 sea nymph that i have restored but i do mot know what the modle is i am looking for the factory hull information on it here is a picture of one that looks just like mine
http://www.boatsthatfloat.com/boatdeals/092906_Seanymph.jpg
can anyone help thanks
Ok I trimmed the motor today
I notmaly ran the trim bar at the second hole up from the bottom or closest to the transom. which caused the boat to nose dive and lean to the left. So I moved the trim bar to the 3 hole from the bottom WOW what a difference it made boat came up on plane good and no...
ok I have another ?
50 HP Evinrude E on a 1980 sea nymp boat at 3/4 throttle the boat does great but at full throttle the boat leans to the left. I have a 17 pich prop on it and i was woundering if i went to a 15 pich prop would that help the lean it seems as if from 3/4 and full throttle there...
First i would like to say hi to all I am new to the forum and seeking some help any would be appriciated.
I have a 1980 50 HP evinrude E on my bowfishing boat I took it out this weekend duckhunting and it ran great to my duck hole about 3 miles up river.
when it was time to leave i fired the...
