Hi
my trim/tilt only works in the down position. Tested switch and relays all is working. I read a post about a limit safety switch that could be a possabile problem/ if stuck, up position won't work. Is this switch down by the tilt motor or in the engine area? Boat is in the water and can't...
I have a 1969 Dixie that I have been restoring over the years. Does anyone have a trick on removing pits in aluminum? The windshield has minor pitting in it's frame and I would like to work on it without removing it from the boat.
I have a 2001 Johnson 115 J115PLSI and the left side greese fitting won't except greese. I changed the fitting and still have the problem so obviously the greese is hard inside. My question is how to free it? Can I heat it with a flame or is that not advisable? This is the fittings on the tube a...
I have a 2001 Johnson 115 hp J115PLSI and I am looking on line for a oil sending unit float switch and I am not having any luck. Does anyone know where I can find one?
should replacing the fly wheel cover on a 2001 Johnson 115 be left to a professional because of the armature and timing settings on it? I looked in the Seloc manual and there is no metion on how to go about it. Is there a tork on the covers bolts?
went to start boat and starter turned over fine then made a bad grinding noise. when I checked the engine I found that the starter bendix cover was cracked in half? what might have caused this, could engine be siezed?
