Re: Force 125 tilt/trim question on 87 Bayliner Bass Boat
Here are two photos, one of the leaking cylinder and one of the Pump. Notice the brass fittings that have been used, it is my guess that the threads had been stripped so had to redo using the larger brass reducer. Inside the red oval...
Any ideas where one get the Plexiglas windshields made or locate some off a junked boat.
1987 18ft Bayliner Bass /Ski Boat. Any and all ideas / suggestions appreciated. :)
There are two cylinders and which one is trim and which one is tilt. The one on the right appears to have a slow leak as the outside of the cylinder is very dirty. Also the motor will very slowly move down from a full tilt. The trim will also very slowly go down. It will trim out and then...
Just curious as to what year my
Force 125 is. Model 12564X7A Serial #2226 Where can I find out. Sort of figured it was an 86 or 87.
It is on my 1987 Bayliner 17 ft Bass/Ski boat that I purchased a few weeks ago.
How does one fill the reservoir on the 125 HP Force. I can see no opening on the top. If needed I can take a picture and post it. Thanks in advance. :confused:
I have attached a picture of the two brackets I have. The top one came with the 125 HP Force and the bottom one is for my 90 HP force. Which is the best to use. I like the bottom one for ease of putting it in place. The top one is a pain in the behind as it is a 2 person job,it slides on just...
[SIZE=4]Have attached a picture looking up at the bolts holding the lower unit on, There are three small holes as one can see. also on the other side side of the lower unit. Any ideas what these might be for or why any one would drill them there.. There is no oil leaking out of them but water...
I just purchased a 87 Bayliner w/ 125 HP Force I set up a large water trough to test run the motor. Runs good but a small amount of oil is on the water after after it is done running. Could that be caused by excess oil in the gas. Or where else could it come from. I did not run it in gear, just...
