Hello -
I just got a new to me center console boat this spring, and it has a 1999 Johnson 225 J225PXEEN on it that has good compression and was running well. I replaced fuel lines only on the motor to the tank and the priming bulb (were dried out and cracked). The VRO is working and is hooked...
Recently I was out on the water and my outboard developed dramatic surging around 3500 RPM thru WOT randomly and inconsistently. This is the first time this problem has every happened. I took it easy and limped back and when I returned to the dock and opened the hood, I noticed the block was...
I want to share a success story that might be interesting to some people out there. I had an overheating problem last summer which ruined my 1990 150 evinrude crossflow and after blowing tons of money changing ignition parts and carb rebuilds, I eventually gave up on the motor. In the fall I...
So I just had a new to me 1993 Ocean Pro 150 put onto my 1990 Seaswirl Striper 210 WA. On my first outing, I tested two 4 blade turning point props. One was a 14x17p and the other 14x19p. the 14x19 was too much prop and killed my WOT RPMs to near 4000-4200 and top speed over ground of...
I have a 1993 Evinrude 150 ocean pro, and it does not appear that my throttle bodies have idle mixture screws. Anyone able to speak to this? Carbs were rebuilt with new kits and cleaned and blown out. throttle bodies cleaned as well, but I do not see the mixture screws that ive seen on other...
I have a original stator on a 1993 Evinrude 150 ocean pro. I have tested it following the service manual procedures and it is not grounding out, it appears in good condition, however the voltage output on both halves from cranking the motor is only 75v, where testing procedure calls for it to...
I have purchased and installed a new CDI power pack and optical sensor, matched with new CDI spark plug wires and using a spark gap tester tool. After following the CDI instructions and steps, I noticed that the entire port bank has no spark, and the starboard bank has very clear spark that...
Hello,
This is my first post, I recently acquired twin 1993 ocean pro 150s that were in rough shape. I managed to salvage one complete motor by swapping good parts onto one of the motors. Now I am left with a slew of parts that would be a shame to waste, so my question is has anyone ever done...
