Recent content by rick derrick

  1. R

    no fuel?1998 evinrude e150jlecd

    engine will start after being primed but will die where should i start first?:confused:
  2. R

    1998 105 model e150jlecd jet drive no fuel?

    engine has always run perfect,took out yesterday started fine,when i got on the gas no power,squeezed the fuel ball a couple of times would run then die,seemed to run if you kept squeezing ball. kicker runs off same tank wheich runs fine but big motor does have a water seperator filter any help...
  3. R

    pivot pin 30 hp evinrude

    which direction does the ****er lever usually go when you pull out the pivot pin by mistake when motor is mounted on boat /getting ready to try to realign this weekend thanks for all the advice:confused:
  4. R

    1988 evinrude 30hp pivot pin oops,pulled wrong screw,won,t go back in,

    PULLED WRONG SCREW WAS GOING TO DRAIN OIL NOW PIVOT PIN WILL NOT GO IN CAN,T EVEN SEE HOLE TO ALIGN,ANY IDEAS ?GOING TO TRY AND TIP UPSIDE DOWN AS NEXT STEP:facepalm:which direction does the shifer lever usually go when you pull the pin out?
  5. R

    30hp evinrude pivot pin on lower unit next to drain hole

    help i can,t get pivot pin back in lower unit.i pulled it out thinking i was going to drain oil,now will not go back in any ideas?????:facepalm:
  6. R

    30hp prop

    i have a 30hp evinrude i think i have a spun prop when i accelerate,and start to get a load on it it revs up,let off the gas and idle its ok. cant tell by looking at prop bushing seems to look ok not sure.pushing a 12ft sorenson.
See more
Top