Recent content by Rip & Tear

  1. R

    2010 90HP EFI 4-stroke Merc dies after throttle and runs rough after warm

    What ended up being the problem? I'm having similar issues
  2. R

    1999 Johnson 25hp 3 cyl 2 stroke oil lines

    If you can't be bothered to help someone then don't bother post that you could. This forum exists to do.just that... Help each other. Enjoy your potatoes!
  3. R

    1999 Johnson 25hp 3 cyl 2 stroke oil lines

    Congratulations on having 8 of these! If you aren't wanting to help me, why did you even reply? Are you bored?
  4. R

    1999 Johnson 25hp 3 cyl 2 stroke oil lines

    If you have one there can you send me some pics. None of my local shops have had one there to check out.
  5. R

    1999 Johnson 25hp 3 cyl 2 stroke oil lines

    Still haven't gotten any further on my search. I have 3 90 degree fittings that look like they go into the intake manifold and I have 3 straight fittings that I think go to the crank bearings. Using a vacuum gauge, I can see vacuum and pressure at the 90 degree fittings and only vacuum at the...
  6. R

    1999 Johnson 25hp 3 cyl 2 stroke oil lines

    Here's how it was when I recieved it. I don't trust what was there to start with. Data tag is faded, but I think it's a Model BJ25PL3EEM
  7. R

    1999 Johnson 25hp 3 cyl 2 stroke oil lines

  8. R

    1999 Johnson 25hp 3 cyl 2 stroke oil lines

    Whether I keep the oil injection system or not. I'm looking for the oil recirc line routing. I can't find any good pics or diagrams in the manual.
  9. R

    1999 Johnson 25hp 3 cyl 2 stroke oil lines

    Hello, I'm trying to replace the oil system back onto a motor that was brought to me. I was able to get the oil injection lines back into place, but I can find the routing for the Oil lines to the crank bearings in the case. Manual doesn't mention them. Can someone send me pics or let me...
  10. R

    25hp Johnson - gas going into oil tank, want to disconnect oil injection

    That's what I think they are, and I think they directly oil the crank bearings. Does anybody have pics of these lines and their routing. Thanks
  11. R

    25hp Johnson - gas going into oil tank, want to disconnect oil injection

    I've got one of these motors that someone removed the oil system from it. They left open fittings on the port side of the motor that go into the case and intake manifold. Can you send pictures of what the plumbing is supposed to look like on that side?
See more
Top