This is the first time since I purchased the boat that I changed the impeller. Everything went fine with the removal of the lower unit and impeller. I cleaned up the impeller housing and all of the bolts. The problem I am having is inserting the lower leg back into the motor and lining up the...
I have a 1982 Chrysler 75 hp engine 756H2H and would like to replace the starter. I have removed the two nuts on the top of the starter and disconnected all of the wires attached to the starter. I can't get it to budge from the mounting bracket. Is there some other way to get the starter out...
I am having problems starting my 1982 Chrysler 75 hp engine 756H2H . The problem seems to be it will crank for 3 seconds and stop even though the key is still in the “start engine” position. If I retry the engine will crank again and stop after 3 seconds. After 10 minutes of this “trying to...
I have a 1983 Rinker V153 that I purchased last year. I have been having trouble finding a Spectrum patch paste that matches the boat. It is a pastel blue gel coat but I can not find an old brochure that indicates the color. If anyone has a old brochure for 1983 Rinkers I would like to know...
I am preparing to change the gear lubricant in my 1982 75 hp Chrysler outboard model # 756h2h. My owner's guide does not list the capacity for this gear box so I do not know how much to purchase. Also are there o-rings, washers, or gaskets I need to buy to seal up the three screws that will...
I am considering buying a 15 ft Rinker with a Chrysler 1982 Chrysler 75 hp outboard attached. In checking out the boat and motor I have a few concerns that I would like to run by the forum. The boat and motor are very clean and seem to be well taken care of - no rips or tears in the vinyl...
