Trim operates fine oil topped off - Just makes a rattling sound as it is raised or lowered. Before replacing motor looking for advise maybe not motor and bearing instead.<br /><br />Thanks in advance
Is there any years that I should stay away from in re-powering with a 200-250 Johnson etc. Would like to use Johnson so my controls will still work.<br /><br />Going from a really great but well used 235 looper to something equivalent.<br /><br /><br />Any help would be appreciated - Trying to...
I am having trouble with the yellow wires from the stator heating up on my 200hp 1994 NON-EFI Mercury engine. I have swapped the voltage regulators and the problem follows the regulator. I have also replaced the regulators and the wires still heat up. Is there any way to test these with a...
When my engine is off and sets for 1 or 2 weeks it appears that the oil injection still pushes oil into the gas line as evidenced by a lot of smoke at startup and if I pull the enrichment valve hose from top carburetor I see almost pure oil. The longer it sits the worse the problem. I have...
Should I be able to blow through the poppet valve hose with the engine off?<br /><br />(Hose attached to the poppet valve still mounted on the engine.)<br /><br />Mercury 200hp V6 1994 carb <br /><br />Thanks<br /><br />RFish >()> :)
I RESENT THE INSINUATION!!!! THAT MY POST WAS ANYTHING OTHER THAN WHAT IT WAS. A LINK TO MERCURYS SITE TO SHOW A NEW MERCURY ENGINE I POST HERE ALL THE TIME I SIGN IN WHEN I DO IT AND DONT HIDE. NEXT TIME BEFORE YOU ACCUSE ANYONE OF SOMETHING YOU NEED TO GET YOUR FACTS STRAIGHT. MY ONLY...
Anyone know where the secondary serial number is located on this engine? I thought saw that it was somewhere on the starboard side of the block any ideas as to where as I did not want to have to take off the packs to check under them.<br /><br />Thanks
Can anyone tell me the correct way to check the reed valves on a 1994 200hp MERC carbureted engine.<br />1. Running at idle<br />2. warmed up <br />3. pull bleed hose.<br />4. plug in PSI guage.<br /><br />Im am only getting 1-2 psi with a lot of pulsation.<br /><br />Should all ports read...
