Recent content by robtado

Sorry about that . The red flag on the primer valve is inline with the valve. It's running hotdogs ways. :)

I will have to test the spark on the plug wires when I get it back together , I took the carbs off to check float level... but last week when i used a spark gap tester everything seemed to be ok.. the red flag on the primer pump is inline with the pump

I have also read on some forums that the tilt/trim sensor on some outboard might affect the engine being in a slowmode... would this model be affected by something like that because the trim sensor on this boat has been cut off.

It has a new sierra 18-7352 fuel pump.

Thankyou again formally the help. For an update I have completely rebuilt the engine .I had one of the cylinders bored .030 over and installed new piston and re ringed all the other pistons. Compression is back up to 100+ on all cylinders. I installed all new spark coils and installed a spare 6...

Thank you for your reply. The reason I asked if anyone knew it was factory ,was because there is a small brass plug that almost looks threaded from inside the cylinder almost directly inline with that hole on the crankshaft side of the block right next to the crankshaft journal. Great idea with...

Hello yall, i was wondering if anyone who has some experience with these engine could give a liitle input on my situation. i have a VE100SLESB 100 hp evinrude outboard. it is a flatback v4 crossflow engine. my problems started when i bought the engine and it had off compression.the 2 cylinders...