Recent content by Robtile

  1. R

    Carb fouling at low speed / Idle?

    I saw what appeared to be a well-maintained 2003 Evinrude 9.8 HP 4 stroke today (pull start) at my local marina. The marina told me that the history of the engine was that they had fouling problems with it. It was used as a kicker and when it would run at low speeds for long periods, the carb...
  2. R

    flasher / fish finder interference

    I just purchased a new boat and I have a Garmin 176C Fishfinder/GPS and a Lowrance 1440 flasher unit. Both transducers are mounted next to each other on a mounting board on the transom.<br /><br />The flasher is going crazy, reading 100 ft. then 60 then 20, back up to 100 ft, etc. I've tried...
  3. R

    Etec / Perco Switch Electrical Fire

    I don't think this warning is specific to an Etec, but I'd like to share as a heads up and warning. I was installing a Perko battery switch, and a mounting screw (barely) pierced the #2 battery cable insulation. This caused a direct short from the positive side of the battery to the boat...
  4. R

    50 HP Suzuki vs. Johnson 4 Stroke

    Any opinions on a new Suzuki 4 stroke vs. the new Johnson 4 stroke EFI in the 50 to 60 HP range. I got quotes on a 50HP today for both. For motor and controls, Suzuki wants $6400 vs. $6000 for the Johnson. This surprised me. I worry about Suzuki because they have so few dealers; however...
  5. R

    Best Cold Starting Motor?

    I'm in the market for a new motor - between 50 and 60HP. However, I am a duck hunter and cold starting is critical. I've been thinking about a 4 stroke, but am worried that the oil viscosity in cold weather may complicate starting.<br /><br />I currently have a 55 HP Suzuki 2 stroke that is...
  6. R

    Suzuki DT55 flooding

    Wow, and I *mean* flooding. Any ideas on what to look for out there?<br /><br />Gas is pouring out of the center carb when starting. My guess is the float, but is there a *specific* piece to look for when tearing into the carb causing the problem. I've never done this on an outboard, but...
See more
Top