Recent content by rockpile

  1. R

    Prop hub 1959 10 hp

    Is there a rubber hub on a 1959 10hp johnson that could be slipping?
  2. R

    1996 150 Johnson No spark on #1

    I have a 96 150 johnson OIS. I have no spark on #1. I switched primary coil leads with the cylinder below, problem followed. Obviously not the coil. I looked through the CDI test sequence and it doesn't show "No spark on 1 Cyl". Conventional wisdom suggest's it is the power pack, My question is...
  3. R

    OMC 2.3 mallory distributer ?'s

    Engine will not start. While checking the spark on #1 cylinder, I notice the timing mark erratically moving around. When it would be near 8' BTDC it would have 1 quick fire, but not start. Then the mark would dissappear, either back fire through carb or briefly stop cranking. Obviously...
  4. R

    Yamaha gearcase seals

    Has Yamaha always put drive shaft and prop shaft seals in facing the same way? and can you put them in back to back? 1990 80hp
  5. R

    oil in cylinders

    Where are the possible places for oil to enter the cylinders on a GM 283? Enough to hydra-lock this thing.
  6. R

    1985 Evinrude 90 Trim problem

    1985 90 hp Evinrude. Trim will go up at idle and even with about 1/4 throttle or so, but not at cruising speed. Any thoughts?
  7. R

    Minn kota power drive help please

    I have a Minn kota power drive bow mount that will spin but will not turn in either direction. Where can I get a wiring schematic or trouble shooting chart? Or is there a common problem to check for?
  8. R

    Finding a 40 hp stator

    1996 40 hp 4cyl mercury serial #OG292045 Looking for the stator. Every where I look, the serial numbers for 1991-1996 40 hp 4cyls, end at OG 291031 Mine begins with OG292045. This one falls into the "red stator kit" fiasco, correct? Where do I find one? If looked here but no luck. Thanks.
  9. R

    Yamaha model year ID

    IS there a place on this site or a link to finding the year of a yamaha? This one is an 8hp 8SJ 6G1 s 020202. But I would still like to know where to find out for future references. Also, where is the shift rod disconnect on these motors?
  10. R

    1969 1000 merc 100 hp ignition

    Would the distributer cap or plug wire be the only place to be the cause of no spark on #4 cyl?
  11. R

    120 sport jet questions

    120 Mercury sport Jet Force power head Is it normal to have the primer installed on these motors, and not have wiring all the way to it? That is the case here. I have power all the way to the engine harness plug at the engine, but it stops there. There isn't even a female terminal inside the...
See more
Top