I just bought a 2004 tundra18 sc with 150xr6 merc. and I notice the prop hub is a little smaller than gearcase hub.
the prop is a trophy plus21pitch. I thought v6 merc motors use the bigger hub size? is there performance lost on this. like Rpms,speed...??
2nd questionis, i want to purchase a...
hello<br />Does anybody know the suggested RPM range for 45hp commercial Johnson '89' <br /><br />model# CJ45WMLE<br />serial c 8248866<br /><br />thanks in advanced
Hello<br />I just replaced my 12/24 OMC trolling motor with used Minnkota 74 maxxum series. I installed it properlly by at the red wire to the positve end and black to the negative end of a 2-12 batteries(in series. My doubt is the speed/power? <br />On my 18 foot fish and ski (2400lbs+-) i...
hello ,<br />can someone assist me with my trolling motor problem.<br />i have the scout 12/24v trolling motor, and the dial for 2nd and 3rd gear on both 12/24 v setting doesn't work.<br /><br />With this model being out for such some time, is this common problem and what do i need to do?<br...
hello ,<br />can someone assist me with my trolling motor problem.<br />i have the scout 12/24v trolling motor, and the dial for 2nd and 3rd gear on both 12/24 v setting doesn't work.<br /><br />With this model being out for such some time, is this common problem and what do i need to do?<br...
hello ,<br />can someone assist me with my trolling motor problem.<br />i have the scout 12/24v trolling motor, and the dial for 2nd and 3rd gear on both 12/24 v setting doesn't work.<br /><br />With this model being out for such some time, is this common problem and what do i need to do?<br...
I have bayliner cobra 87 fish and ski and i had a jackplate installed for vertical adjusting. so far i have learned that the cavitation plate should be coplaner with the under side of hull.<br />but the design of the v-hull ends flat 20 inches before the transom. note that i have 2 hulls at...
i have a 2003 mercury 115hp with a alum 3x13x21 prop.<br />I am intersted in improving fuel economy and optimizing my top end by getting a stainless prop. I have been told that by merc that the laser2 would be the best for my wishful application, anf Michigan wheel mentions that the ballistic 3...
Hi guys<br />i have a 2002 115 mercury and the starter drive sticks and it will spin(counterclockwise???) but it won't elevate to catch the flywheel. please help me out because i added grease and it still sticks. the only way it will elevate on the thread is by manipulating the starter drivee...
Hi guys<br />i have a 2002 115 mercury and the starter drive sticks and it will spin(counterclockwise???) but it won't elevate to catch the flywheel. please help me out because i added grease and it still sticks. the only way it will elevate on the thread is by manipulating the starter drivee...
Have a 18ft. fiberglass with v-front and flat bottom; 115hp with hydro foil fins at the cavatation plate. Cannot go OWT with out porpoising or cannot avoid porpoising at top end speed. the bow goes up-and-down even on flat water. note the mechanics lower the motor at its lowest seeting...
