Recent content by rohdemedic

  1. R

    Intermittent Lean Condition

    I have a 1993 Evinrude 120 TLETFG 03293376. Rebuilt last year overbored the cylinders .004 Cleaned carbs link and sync after rebuild. Starts and runs fine for the first 4 or so times per trip. After that it will become difficult to start. It has a whistle and a wheeze right before it...
  2. R

    Oversize carb jets?

    Hey all, Rebuilt evinrude 120 bored over .004. Boat would initially not idle. Enriched idle air mixture, would idle and run great but not idle or run after sitting for 30 mins. Enriched idle air mixture as far as screw would go, improved a lot but did not fix the problem. I was told I need...
  3. R

    Intermittent lean condition

    :confused: Hey guys, thanks for all of your help in the past. Rebuilt a 93 evinrude 120 v-4, it had thrown a piston. Took it in for link& sync and to have the carbs set (rebuilt those also). Ran great on the hose. Ran lean in the water and would not idle. Took it back and they enriched the...
  4. R

    gasket sealer

    Evinrude 120 v-4 120 1993. Hey all. when attaching the powerhead to the lower unit I in my infinate wisdom put gasket sealer on the gasket. Question, does this warrant pulling the powerhead off or is it unimportant? Thanks again.
  5. R

    1994 v-4 120 looper fuel recirculation hose routing

    Hello, I am looking for the fuel recirculation system hose routing as well as the primer solinoid hose routing. i rebuilt this enging and this is the last step in the shop. Not in the manual and I can't find it online. Thank you Matt
  6. R

    evinrude 120 v-4 1993 primer solenoid hose routing

    Hey Guys Does anyone have the primer solinoid hose routing for a 1994 evinrude 120. E120TLETF. Someone already gave me the crank vent routing. Still have extra hoses. Thanks guys your lifesavers. Matt
  7. R

    evinrude 120 1993 crankcase vent hose routing

    Hey all. I need help. Does anyone have any information about the proper routing for the crankcase ventilation hoses for an evinrude 120 v4 1993? I did a powerhead rebuild and the digital pictures I took did not show enough detail. I can't find any information in the manual or on line...
See more
Top