I took pictures before I disassembled the carborator. Suggestions about a possible used carborator replacement for this motor. Or Suggestions dialing in the mixture. The poping occurs as the engine warms . My instinct is to walk back and push down on the throttle to idle down. The way that...
2003 FW. Freedom 180 . 3.0 engine mercruser block sx outdrive, mercarb is an 80s model. Questions first start after winter. Used starter fluid to get it going. Runs rich then falls flat engine dying. This is on the hose.It will start again first turn. Should I start and idle in the water...
Thank you. Swapped it out as well as starter selinoid and starter. Aç voltage from stator pulse wire is 36 then 50 volts ac stator ohms tests good 👍.
2 yellows show 36vac. This only cranking. Cdi coil primary is good. Secondary sp wires show 3.9 this is out of range of tables. Would this...
After installing a cdk2 and then bored it out to 40mm with the 750 jets & low / high speed screw set to a 91650specs it.runs great. Until a no restart. No spark. And a Secondary coil reading of 16.2k. I'm thinking the regulator rectifyer is spent.& not charging the battery with enough CCA...
How much time or hours is a safe time to replace this filter? Is it a good idea to empty water out of this filter in between replacing with a new one? Thank you.
Since it's stuck in full up position would that indicate a short in the grounded side? Would it be worth the effort to unbolt sender cover and check the condition of the 2 terminals? The gage worked 3 months ago and has not been in the water since. Is there 2 lugs that are apparent with the...
Thank you. Do you know if the 2003 sx outdrive has the same clip style that is very hard to unclip?The clip is where the wire passes through the transom. This needs to be sealed?
The trim Motor works as it should. The gage always indicates as down position.
If I unhook the wire connection inside the bilge and connect the wires togather coming from the gage? Will this jump the needle or is it by grounding the positive side? If I turn the drive to port is the selinoid...
