I'm wanting to change the impeller in my 1984 40hp evinrude model# E40RWCRA. I bought the impeller already. Do i need to change the impeller housing seal also? 2nd question. Is this change any different than changing the impeller on my 66 20hp Johnson? Thanks, Roy
I have a problem with my spark plugs. The gap keeps
closing on them. The motor had L77jc4 plugs. The boat shop gave me QL78YC. I dont know if the heads has been machined, but the QL plugs sit deeper in the cylinder and wont hold the correct gap. Do i have the wrong spark plugs? ... 1984...
I have a super 40 that im trying to get running. The motor is the commercial model, Rope start only. Is there a trick to starting these? When i pull the rope it sucks back so hard every now and then that it feels like my wrist is going to break. I had it started for a second so i know it will...
Hi folks, I have a 1984 evinrude super 40 that I want to make electric start. It's model# E40RWCRA. I need to know what years of flywheel and starter will interchange to complete this. Thanks, Roy.
I have a 59' sportwin that uses a pressurized tank. Im getting orange fuel out of the tank. I have taken the fitting off so I can pump the gas out. It will be orange for a few pumps then gets back to blue. I let it set for 5 minutes and it pumps orange again for a few pumps. Is there something I...
The motor runs great, but the tiller handle doesnt open the throttle all the way. I cant move the timing plate anymore and the handle wont turn any further to get to open throttle. What can I do as far as any more adjustments or is something broke? Its a FD 22M.....Thanks, Roy
Hi folks, I have a quick question on my plate height. I have a 95 alumacraft v16. My motor is a 68 johnson 20hp short shaft. The plate is about an inch below the bottom of the boat. I can raise the motor about 1/2" by placing a piece of wood under the bracket. Will this improve performance or...
Hi folks, I want to add a starter to my 68' 20hp johnson(FD 22M). It has the starter ring on the top already, but I cant find out what else I need. I have looked at both the BRP and boat.net parts diagrams and dont see the starter set up on either Can somebody let me know what I need?...Thanks, Roy
Hi folks, Im trying to get my 68' johnson(FD 22M) running. The motor runs great w.o.t. Im having problems with the low speed(trolling). When I adjust the low speed setting , it doesnt change anything. I can screw it all the way down and it still doesnt change. I have cleaned the carb. What would...
I have a 68' johnson (fd 22m) 20hp. I need to know which spark plug to get. I have found 3 different plugs recommended for the motor and dont know which would be best. The 3 are j4j, j6c and j8c. Can anybody help me out?..Thanks, Roy
I want to repaint my 68' 20hp Johnson(fd-22m). I would like to get it back to original colors and cant find pictures. It looks like everytime they used it they added another coat of camo paint.....Thanks, Roy
I have a 10hp Jubilee that is in great shape , but I'm having a problem. The motor starts right up and runs great except that it has a chug in it when I get past half throttle. I have set the high and low speed the way J. Reeves says to do it . The motor purrs like a kitten at low speed. What...
