Hi I have a 97 Mariah Z 276 I want to remove interior to send to upholster to be refinished the seats are easy but the side panels have no visible attach points they are vinyl with a button in middle every foot or so the buttons unscrew I thought maybe a plastic insert like a car door but when...
Does anyone know the part number or where I can find the parts mine are missing and I think that would cause my small leak 5.7 GSI SX-M drive grommets are at outdrive Thanks
Hi I have 87 Wellcraft Antigua 265 and the galley was removed and replaced with a bench and storage out of a couple sheets of plywood. Ive seen pictures of the galley looks like it would have weighed more than what was built. I was wondering should I add some weight as the original design was...
Hi I have a 87 Wellcraft Antigua on a 91 Magic Loader trailer the boat always went on sideways noticed all keel rollers were shot replaced all with boat on trailer one self centering and 3 regular. When winching onto trailer boat is tilted to starboard what adjustment do I need to make to fix...
Hi after some new valves engine running great only issue is idle.It goes from 1000 to 700 and back doesn’t stall and no hesitation on acceleration just won’t stay steady it is fuel injected 5.7GSIPWTR What should I look for?
Hi 5.7GSIPWTR Had a misfire checked heads had 3 bad valves had them replaced as well as seals and guides and machined both heads. New plugs,wires,cap, and rotor. Engine not running right plugs look ok except 6 is carbon fouled. Compression 170 on all cylinders. Leakdown on 6 is 35% and on 1 is...
Hi 5.7GSI PWTR Engine Misfire new plugs wires and cap all plugs normal except number 6 loaded with carbon. When I started it up to warm up for compression test had lifter noise for about 20 seconds and then went away and misfire didn't start at first as soon as temp gauge started o move. Engine...
Hi 87 Wellcraft Antigua 5.7 GSI SX-M drive So had her out today and lost engine It would not start while waiting for a tow did some investigation found the wiring harness 10 pin connector at relay box on starboard side is very touchy if I just touch it cuts out fuel pump I was able to get home...
I have a 5.7 GSI changed intake gaskets motor was moved with distributer out how do I set initial distributer position and then how do I set timing I have an advance timing light
Hi 2000 Volvo 5.7 GSI when I got it oil level was high I thought previous owner over filled I changed the oil and set level ran engine and checked again was good Ran engine for a while to winterize seems like a lot of fuel coming out of injectors and when I checked oil it was over filled. Oil...
87 Wellcraft Antigua 5.7 GSI Fuel Injected was cruising along at 4000 rpm when engine suddenly stalled and cut right out. I don't here the fuel pump when I turn ignition on will the relay go bad just like that and where is it located? Thanks
Hello I have a 5.7 GSI Volvo Penta DP drive lower unit hit ground after winch hook failed and boat came off trailer.No visible damage to hull but lower unit has a hole in front on bottom as drive was trimmed al the way up at the time of impact. Can lower unit be welded and can water get into...
